RANGE OF MANUFACTERED PRODUCTS
      BRACKISH WATER REVERSE OSMOSIS
  
  
  
  
  
  
  
 
   
 DATA SHEETS | SPECIFICATIONS | MANUALS | DRAWINGS
 
    
 
 
 Typical Features
 Rectangular Design (Circular Design available for special site     requirements)

 Welded Carbon Steel Construction (1/4 inch structural plate), with interior     and exterior lining suitable for above and below ground installation (Tanks     can also be constructed in concrete on site).

 Membrane check valve fine bubble diffuser preventing the back flow of     water when the diffuser is not aerating [up to 12 cfm capacities]. Due to     its self sealing configuration using a flexible membrane, this diffuser is     less susceptible to clogging by solids or biological fouling.

 Aerated sludge holding tank with up to 6 months sludge storage     capacities.

 Cast Aluminum comminutor up to 850 gpm each, for durability and long     life. A built-in torque clutch and auto reverse system protects the gearbox     from heavy shock loads (shredder-type submersible pumps are available     as alternative).

 Blower modules provide a single air source for all mechanical and     electrical components within the plant. Entire module system is protected     by a fiberglass Nema 4x enclosure.

 Hypochlorite Feed by positive displacement pumps to baffled chlorine     contact tank (Gas chlorination by vacuum system is an alternative).

 Motor Controller housed in a Nema 4x enclosure, incorporating the main     circuit breaker, starters, relays, terminal blocks, switches, pilot lights,     fuses and all necessary electrical components.

  print this page
 
© EBD Water® 2006. All Rights Reserved.